Item number: M360F
With auto-ranging up to 1500 V / 20 A / 30 kW
The PROFiTEST-PV permits measurement of characteristic IU curves from individual photovoltaic modules, as well as from strings.
Connect > Switch On > Start Measurement > Read Results > Done!
With the help of a patented process, the instrument is capable of ascertaining peak power, internal series resistance and internal parallel resistance directly on-site “with only one measurement and without entering module data”, which are then displayed at a high resolution color graphic touch-screen that’s suitable for use in sunlight.
Troubleshooting in PV systems, as well as documentation of system quality, are executed quickly and economically during initial start-up and subsequent testing without a long learning curve.
This simple yet decisive test assures safety for the customer and eliminates consequential costs for the installer.
Measured peak power can, for example, also be used in order to determine peak ratio. Beyond this, acquired characteristic curves make it possible to draw further conclusions regarding the electrical characteristics of the measured module or string. And thus the tester is also suitable for use in research and development.
The differences ...
Why is measurement with capacitive load necessary?
On the one hand, measurement of characteristic curves for PV generators (modules, strings, arrays) must not be conducted too quickly (high dV/dt), because the measured characteristic curve may be changed in the case of rapid measurement (< 20 ms) due to the capacitive/inductive attributes of the generator or the test setup, in which case not only the characteristics of the PV generator are reflected in the measurement results. On the other hand, measurement must not be too slow either (> 1 sec.), because the danger of fluctuating radiant exposure is otherwise significantly increased, which would influence measurement results. This affects module temperature as well, which reacts relatively sluggishly but nevertheless can change within a matter of seconds.
Patented calculation process for determining the generator’s internal series resistance based solely on a single characteristic IU curve
This resistance is the physical result of the material used to manufacture the module, as well as its layout and wiring connections, and normally has a constant value. For example, it amounts to roughly 1 Ω for crystalline modules and more than 2 Ω for thin-film modules. As of recently, measurement of internal series resistance can be performed with instruments from the Profitest PV product range. Only a single characteristic I-U curve has to be traced at the module for this purpose. On the basis of this characteristic curve, the instrument automatically calculates RS, as well as peak power PPK and parallel resistance RP.
Theoretically anticipated internal series resistance RS can be calculated. For example, this is possible with the software if the following characteristic STC values are known for the module: Uoc, Isc, UMpp and IMpp.
The calculated RS value can then be compared with the measured value, which is read out by the Profitest PV after curve tracing. If the measured value is too high, wiring must be inspected for interruptions, corrosion, connection errors and underdimensioning.
1 ea. PROFiTEST PV 1500
1 ea. irradiation reference sensor, 10 m connector cable
1 ea. external Pt100 temperature sensor, 10 m connector cable
1 ea. external safety disconnector, 1500 V / 20 A
2 ea. 4-wire measurement cable, 10 m long MC-4
1 ea. external power pack, 60 W
1 ea. shielded mini USB cable
1 ea. case system for accessories
1 ea. PC software: PV Analyzer
In our Download Center you will find all documentations from the product area in English.
If you have questions about the product, need technical information or the current delivery time? Our sales department will be happy to help you!
Under myGMC you can register your product, and receive up-to-date information on firmware updates, standard changes and much more.